Switch between single cardan, front double cardan and two-piece shafts, and calculate each joint's operating angle from signed shaft inclinations.
An SVG side view that follows your inputs shows the positions of shafts and joints. It compares angles in a single plane and does not predict actual vibration.
Registered specifications and reference data matching the model code are linked. Check first-registration date, measured values and unregistered items against your own vehicle.
0vehicle reference inputs loaded. Other fields retain example values; adjust them to the vehicle.
SETTINGS
Adjust inputs
Shaft layout and inclinations
-2020
-2020
-2020
Diagram and results
Updating…
Front joint operating angle (°)2.00
Rear joint operating angle (°)2.00
Front–rear operating angle difference (°)0.00
LIVE SIMULATIONInputs update the diagram
Axles and joints / SIDE VIEW
All calculation results 4 items
Front joint operating angle (°)
2.000
Rear joint operating angle (°)
2.000
Front–rear operating angle difference (°)
0.000
Target pinion angle for parallel layout (°)
-3.000
Save and share these calculation inputs
Copy the URL to share or bookmark these conditions. Inputs are also retained in this browser after changes, separately for each tool and vehicle. URL parameters take priority.
Select and copy the URL. A shared link does not verify fitment or the accuracy of the inputs.
Enter every angle in the same front-to-rear coordinate system, with upward towards the rear as positive. If you measured the pinion flange face, convert it to the shaft-axis angle.
Assumptions
Angles are compared in a single plane, excluding lateral offset and axle wrap under load. Two-piece shafts show three joint angles. Operating angles alone cannot confirm whether vibration will occur.